Panasonic NE-1257R - Installation Instructions for Stacking; Sanitary Counter Top Seal

Installation Ins ructic ns for Stacking
IMPORTANT
NE-1247,
NE-1257,
NE-1258,
NE-1757,
NE-2157,
NE-DF20G
4. The maximum stacking height is the total heights
1. Disconnect the power cord from the wall socket :
of two units.
before attempting installation.
2. For stacking installation, you must use the
PANASONIC Joint Plate which is enclosed with this PR E PA RATI O N
unit.
3. The combination of the units for stacking is limited Be sure the oven cavity is empty. Be sure surfaces
to only the following PANASONIC models: where ovens meet is clean and sanitized.
INSTALLATION
1. Stack the units and remove five screws (a) as shown in Fig.1.
2. Loosen the screw (b).
3. Projection on Joint Plate must face away from the oven. Place Joint Plate on the screw (b).
4. Attach and tighten five screws (a) and the screw (b). See Fig.2.
5. Ensure the top oven is at a safe and workable height.
Joint Plate
Projection
When microwave oven units are stacked on a
counter top, their base must be sealed in
accordance with N.S.F. Standards as per the
following instructions.
1. Microwave oven should be located on a level
counter top surface. Complete the electrical
connections.
2. Thoroughly clean the microwave oven bottom
perimeter and the counter top area around the
microwave oven perimeter.
3. Lay generous bead of silicone seal around the
entire perimeter of the base of each microwave
oven unit.
4. Smooth the silicone seal into the crevice with finger
or tool to provide a cove seal.
Note: Remove the Air Filter from the front of the oven
before applying silicone.
DO NOT FORGET to re-install the Air Filter
after applying silicone.
Silicone Sealant
-15-