Panasonic NE-1257R - Care of Your Oven; Cleaning the Splatter Shield; Cavity Light Bulb Replacement; Cleaning the Air Filter

Care of Your Oven
1. Remove the plug from the electrical socket before 3. The outside surface of this microwave oven should
cleaning. be cleaned with soap and water, then dried with a
2. Keep the inside of the oven clean. If pieces of food soft cloth. Make sure that water does not get into the
or Spilled liquids stick to the oven walls, or between back ventilation or control panel opening since this
door seal and door surface, they will absorb can damage the unit.
microwaves and may cause arcing or sparks. Wipe 4, The window of the door should be washed with very
up ail spills with a damp cloth. Kitchen detergent or mild soap and water. Be sure to use a soft cloth.
an approved sanitizing solution may be used if the Never use window clearer. The front door can be
oven gets very dirty. Do not use harsh detergents or scratched by harsh soap or cleaners.
abrasives.
CLEANING OF THE CLEANING THE AIR FILTER
SPLATTER SHIELD Clean the Air Filter regularly according to the following
instructions. The oven may have problems when the
Air Filter becomes clogged with dust.(*)
1. Remove Air Filter from the front bottom skirt by
returning the right screw to the left. Then slide the
fitter to the right and lift it off the post at the left.
1. Hold snap in-snap out side stoppers of splatter
shield with both hands and pull them in and down.
Then take the splatter shield out of the oven cavity.
2. Rinse splatter shield in soapy water and an
approved sanitizing solution.
3. Be sure to replace the shield before using the oven.
CAUTION 2. Wash this filter in warm soapy water.
Splatter
shield
must
be
in
place
securely
when
3.
Be
sure
to
replace
Air
Filter
before
using
the
oven.
you use the oven. (*) If Air Filter becomes clogged with debris this will
cause an overheating problem on the oven.-
See “F” codes on page 17.
REPLACEMENT OF THE
CAVITY LIGHT BULB
If the Cavity Light burns out, you can replace it
yourself by following these simple directions.
1. Unscrew the Cavity Light Cover which is located on
the left side of the cabinet.
2. Remove the celophane tape that is placed over the
bulb and the socket.
3. Replace the old bulb with a new one.
4. Close the Cavity Light Cover.
use 120 V - 125 V/ 20 W for NE-1257R/NE-1258R
use 230 V - 250 V / 20 W for NE-1757R
use 230 V - 250 V / 20 W for NE-2157R
CAUTION
Remove the plug from the electrical socket before
replacement of the Cavity Light Bulb.
-16-