Panasonic NE-1856-2 - Quantity Pads and Program Lock

- 13 -
E. PROGRAM LOCK
INSTRUCTION DIGITAL DISPLAY WINDOW PAD
1
Keep the door closed.
☛ Digital Display Window must be blank.
2
Press Prog pad until “PROG”, “P” and “L” appear. (more than five
seconds)
☛ “PROG”, “P” and “L” will appear.
PROG
In Program Lock mode:
• The oven is started by pressing the desired Number/Memory pad. There is no need to press Start pad.
• Opening the door cancels the remaining time on the program.
• The oven can not be programmed or run manually until the program lock is released.
◆ To Activate Program Lock:
INSTRUCTION DIGITAL DISPLAY WINDOW PAD
2
Press Prog pad.
☛ “PROG” will start to blink.
PROG
4
Press Double Quantity pad.
☛ The currently programmed magnification number will appear.
Note: 1.6 times is preset at factory.
x 2
PROG
5
Press Number/Memory pads “1” and “5”.
☛ The programmed magnification number will appear.
1
5
PROG
6
Press Prog pad.
☛ “PROG” will stop blinking.
This means that you have completed programming.
PROG
• Three seconds later, Digital Display Window will go blank.
Note:
• If you want to program your desired magnification number for treble quantity, repeat as above, using Treble
Quantity pad instead of Double Quantity pad.
3
Press Number/Memory pad “5”.
☛ The selected pad number will appear and currently programmed
information will be indicated.
5
PROG
1
Example: To program 1.5 times of heating time for double quantity into Number/Memory pad “5”
1
Keep the door closed.
☛ Digital Display Window must be blank.
D. PROGRAMMING DOUBLE OR TREBLE QUANTITY PAD
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (see below)
DO NOT OPEN THE DOOR WHILE PROGRAMMING!
How to Operate NE - 2156/NE - 1856/NE - 1856-2/NE - 1456