Panasonic NI-L45NR

| HOWTOUSEASSTEAMIRON __ |
1. Fill iron with water. See section ° How to Fill Water ".
2. Plug the cord into a standard electrical outlet.
3. Set the iron on the power base securely, the green " OFF “ light will turn on.
NOTE: If the green light does not turn on, replace the iron on the power base
again, otherwise the temperature set pad can not function.
4. Push the "SET ° pad until the red light for " STEAM “starts blinking.
See section “ HOW to Contro! Temperature ".
( Steam Button }
"Water Fill Opening "
" Steam Button "
"steam Button "
Up: for Regular Steam
Med: for Light Steam
Down: for Non-Steam( Dry)
2("MID")
3("HIGH")
HOW TO USE AS A DRY IRON
1. Press the steam button down to the dry position.
2. Plug the cord into a standard electrical outlet.
3. Set the iron on the the power base securely, the green " OFF " light will turn on.
NOTE: If the green light does not turn on, replace the iron on the power base again,
otherwise the temperature set pad can not function.
4. Push the " SET " pad until the red blinking light reaches your desired heating level.
Steam button should be at " DOWN " position. (See drawing above)