Panasonic NI-L45NR

This system activates after the temperature reaches its selected level.
To reheat your iron after it automatically shuts off, simply push the temperature control pad
until the red light comes to the setting you wish for.
"OFF" light(green) remains on after your iron automatically shuts off the power to the heater.
This light indicates that the iron is still plugged into the electrical outlet and voltage is being
supplied to the power base.
HOW TO CARE FOR YOUR IRON
AFTER EACH USE
1. Press the steam button to " DOWN(DRY) " POSITION.
2. Press the " SET " pad until the " OFF/AUTO OFF " light turns on.
3. Unplug the iron.
4. Empty the water from the water tank. DO NOT store the iron with water inside.
5. Push the case cover until heard the sound clicks. It will be locked.
until heard the
sound cliks
MAIN BODY
1. When cleaning the main body of the iron , make sure that iron has cooled down.
2. Wipe the iron with a damp cioth If necessary, use a mild detergent.
NEVER USE ANY HARSH CLEANERS.
SOLEPLATE
* Starch and other residue can be easily removed from the soleplate with a damp cloth.
* To avoid scratching the finish, never use a metallic pad to clean the soleplate, and
never place the iron on a rough surface. l
“if synthetics are being ironed on a higher temperature level as instructed, not only will
the fabric be ruined. but also the solepiate will often be covered with the melted remains
of the synthetic faric.
* The best way to remove synthetic residue from the soleplate is to iron over an old
cotton rag, after heating the iron.
CAUTION:
Never use steam iron cleaners in the iron since it may cause damage inside the iron.
lf the power supply cord is damaged, it must be replaced by a special cord or
THE iron must only be used with the power base provided.
-9-