11
4
4
Set the Steam/Dry Selector to the Dry
position, and then set the Power Switch to
“ ”.
5
5
Preheat the iron until the Thermostat Operating
Light goes out, usually it takes about 1 minute.
The Thermostat Operating Indicator Light will go on and off while ironing to
indicate the temperature is being maintained.
6
6
Use iron after holding it horizontally and setting
the Steam/Dry Selector to the Steam position.
•
Whenever the
iron
is positioned vertically, the
steaming action will stop.
3 position Steam/Dry Selector
Dry Low steam High steam
CAUTION:
Do not aim the steam at any parts of your body or others.
The Thermostat Operating Indicator Light goes on.
• If the temperature of the Soleplate is high, the light
will not go on.
Note
•
The Anti-Drip System will activate when the temperature of the Soleplate’s
surface drops. At the same time, the steam will stop. It is not a sign of malfunction
when you hear a clicking sound. The Thermostat Operating Indicator Light will be
on, wait until the Thermostat Operating Indicator Light goes out.
English
To Next Page
Loading...
