17
English
4. Empty the Water Tank immediately after using. Do not
store the iron with water in it. If you empty the
Water Tank after it has cooled, heat the iron for
about 5 minutes with the Power Switch set to “ ”.
•Do not use the Steam or the “Power Shot” while the Power Plug is unplugged
or the Power Switch is set to “ ”, water will remain inside the Soleplate and
cause staining.
• Do not wind the Power Cord around the iron. It may be damaged by the
hot Soleplate.
5. Wait until the iron has cooled before storing it, and
always set it on the Heel Rest to protect the Soleplate
from scratches, corrosion or stains.
How to care for your iron
►After each use
1. Set the Power Switch to “
”.
2. Unplug the Power Plug.
3. Set the Steam/Dry Selector to the Dry position. If the
Steam/Dry Selector is not in the Dry position after
using, remaining water will move into the Soleplate
and can result in burns when the iron is used next
time.
To Next Page
Loading...
