9. Remove 4 screws holding convection outside cover B on
cavity back plate.
10. Remove 4 screws on the face of convection outside cover
B.
11. Release tabs between side of convection outside cover B
and cavity back plate, then remove the convection outside
cover B.
12. Slide the convection inside cover A upward then rightward
and out emphatically, then remove the module, which
consists of convection inside cover A, convection motor and
convection heater.
To replace convection heater
13. Remove 1 screw holding heater bracket A on convection
inside cover A.
14. Remove 2 screws holding convection heater on convection
inside cover A.
To replace convection motor
15. Remove 1 nut holding convection fan, then remove
convection fan.
16. Remove 3 screws holding convection fan bracket on
convection inside cover A.
18
NN-CS596S
To Next Page
Loading...
