9. Release tabs between side of convection outside cover B
and cavity back plate, then remove the convection outside
cover B.
10. Slide the convection inside cover A upward then rightward
and out, then remove the module, which consists of
convection inside cover A, convection motor and convection
heater.
To replace convection heater
11. Remove 1 screw holding heater bracket A on convection
inside cover A.
12. Remove 2 screws holding convection heater on convection
inside cover A.
To replace convection motor
13. Remove 1 nut holding convection fan, then remove
convection fan.
14. Remove 3 screws holding convection fan bracket on
convection inside cover A.
15. Remove 2 screws holding convection motor on convection
fan bracket.
22
NN-CS599S
To Next Page
Loading...
