Panasonic NN-DF383B - Microwave Cooking and Defrosting

4.8. Stirrer motor
1. Remove the motor cover by breaking off at the 8 spots
indicated by arrows with a cutter or the like.
NOTE:
After removing the motor cover, be sure that cut
portions are properly trimmed or bent to the inside
so that no sharp edges will be exposed to outside.
2. Disconnect 2 lead wires from stirrer motor terminals.
3. Remove 2 screws holding stirrer motor.
NOTE:
After reinstalling the new stirrer motor and
reconnecting the 2 lead wires, reinstall the motor
cover by rotating it around 180, tucking the 2 tabs
under the base in the 2 provided slots, then screw
the single tab to the base using a screw.
4.9. Lower Heater (Heater AU)
1. Remove left and right door key springs from door arm.
NOTE:
Support door before removing door springs.
2. Disconnect connector of power supply cord.
3. Turn over the microwave oven.
4. Remove 5 screws holding base plate on the bottom of oven
cavity.
5. Remove 4 screws holding left and right hinges.
NOTE:
Do not remove the two screws holding the left and
right hinges on the bottom of cavity front plate.
18
NN-DF383B