En-7
English
Controls and Operation Procedure
Operation guide
If the delay/stand pad is pressed 4 times, this will turn off the operation guide. To turn the
operation guide back on, press the delay/stand pad 4 times.
Clock Setting: Example: To set 12:10
• Press Clock Pad once.
The colon starts to blink.
• Enter the time by using the
Time Pads.
The time appears in the
display and the colon blinks.
• Press Clock Pad.
The colon stops blinking and
the time of day is entered.
NOTE:
1. To reset the time of day repeat all the above steps.
2. The time of day is displayed, unless the power supply is interrupted.
3. This clock has a 24 hour display.
To Next Page
Loading...
