8.5. Avoid inserting nails, wire, etc.
through any holes in the unit
during operation.
WARNING
Never insert a wire, nail or any other metal object through the lamp
holes on the cavity or any other holes or gaps, because such objects
may work as an antenna and cause microwave leakage.
8.6. Confirm after repair
1. After repair or replacement of parts, make sure that the
screws of the oven, etc. are neither loose nor missing.
Microwaves might leak if screws are not properly tightened.
2. Make sure that all electrical connections are tight before
inserting the plug into the wall outlet.
3. Check for microwave energy leakage. (Refer to procedure
for measuring microwave energy leakage.)
CAUTION
MICROWAVE RADIATION
DO NOT BECOME EXPOSED TO RADIATION FROM THE
MICROWAVE GENERATOR OR OTHER PARTS CONDUCTING
MICROWAVE ENERGY.
IMPORTANT NOTICE NEW H.V.
1.The following components have potentials above 2000V while the
appliance is operated.
* Magnetron
* High voltage transformer
* High voltage diode
* High voltage capacitor
Pay special attention to these components.
2.When the appliance is operated with the door hinge or magnetron
fixed incorrectly, the microwave leakage can reach more than
5mW/cm
2
. After repair or exchange, it is very important to check if
magnetron and the door hinge is correctly fixed.
13
NN-S262SF / NN-S262BF / NN-S262WF / NN-S252BF / NN-S252WF
To Next Page
Loading...
