9.9. Fan motor B (for magnetron
cooling)
1. Disconnect 2 lead wires from fan motor B terminals.
2. Remove 4 screws holing fan motor B(U)Assembly.
3. Remove 4 screws which holding fan case installation plate
on the fan case C.
4. From interior of fan case C, remove 2 screws holding fan
motor B.
9.10. Turntable motor
1. Disconnect 2 lead wires from turntable motor terminals.
2. Remove 1 screw holding turntable motor.
3. Release from retainer tab by turn spinning certain angle,
remove turntable.
17
NN-S262SF / NN-S262BF / NN-S262WF / NN-S252BF / NN-S252WF
To Next Page
Loading...
