Cooking
1
If
cooking at high power (10),
skip to step 2. Press
Power Level
until the desired power level
appears in the display. P10 is the
highest and PL1 is the lowest.
2
Set Cooking Time using the
Number pads. For all power
levels, the max. working time is
99 mitues,99 seconds.
Setting a Standing
Time
1
Some recipes call for a standing
time after cooking. To do this,
repeat steps 1 and 2 in the
Cooking
section on previous
page. Then press
Timer
.
Note: Donot skipstep 1, even use
high power P .
L10
2
Set desired amount of stand
time using
Number
pads (up
to 99 minutes, 99 seconds).
3
Press
Start
. The timer will start
and then beep twice at the end
of cooking time (the beginning
of standing time). Five beeps
will sound when standing time
is done.
3
Press
Start
; the cooking will
start and the time will count
down in the display. At the
end of cooking, five beeps will
sound.
NOTES:
1.
For reheating, use P10 (HIGH)
for liquids, PL7 (MED-HIGH) for
most foods, and P6 (MEDIUM)
for dense foods.
2.
For defrosting, use PL3
(MED-LOW).
DO NOT OVERCOOK
: This
oven requires less time to cook
than older units. Overcooking
will cause food to dry out and
may cause a fire. A microwave
oven’s cooking power tells
you the amount of microwave
power available for cooking.
Stage Cooking:
For more than one stage of
cooking, repeat steps 1 and
2 for each stage of cooking
before pressing
Start
. The
maximum number of stages
for cooking is three. When
operating, two beeps will
sound between each stage.
Five beeps will sound at the
end of the entire sequence.
To Next Page