8.3. Troubleshooting of inverter circuit (U) and magnetron
This oven is programmed with a self diagnostics failure code system which will help for troubleshooting. H95, H97, H98 and H99
are the provided failure codes to indicate magnetron and inverter circuit problem areas. This section explains failure codes of H95,
H97, H98 and H99. First, you must program the DPC into TEST MODE, For except SD691S & SD671S models: press Clock
pad once → press Timer pad once → press Start pad once → press Power Level pad once, For SD691S & SD671S
models: press Timer/Clock
button twice → press Start button once → press Power Level button once. Program unit for
operation. H95, H97, H98, H99 appears in display window a short time after [Start] pad is pressed and there is no microwave
oscillation.
Alternate way to troubleshoot oven with AC Ampere meter used
H95, H97, H98, H99 appears in display window a short time after [Start] pad is pressed and no microwave oscillation with AC
Ampere meter used for troubleshooting.
24
NN-SD691S / NN-ST681S / NN-SD671S / NN-ST671S / NN-ST661S / NN-ST661B / NN-ST661W / NN-ST651B / NN-ST651W
To Next Page
Loading...
