4.6. Turntable motor
1. Remove the motor cover by cutting, at the locations
indicated by the arrows, with a cutter.
NOTE:
After removing the motor cover, be sure that cut
portions are properly trimmed or bent to the inside
so that no sharp edges will be exposed to outside.
2. Disconnect 2 lead wires connected to the turntable motor.
3. Remove the turntable motor by removing screw.
NOTE:
After replacing the new turntable motor and
reconnecting the two lead wires, reinstall the motor
cover by rotating it 180, tucking the tabs into the
base in the 2 provided slots, then screw the single
tab to the base usinga 4mm × 6mm screw.
4.7. Steam sensor
1. Disconnect connector CN2 from digital programmer circuit
board.
2. Disengage catch hooks on sensor cover C from orifice.
3. Remove steam sensor from orifice.
NOTE:
When installing the steam sensor, make sure that
the direction of steam sensor is as shown in figure.
14
NN-T695 NN-T685SF
To Next Page
Loading...
