31
11 Disassembly and Assem-
bly Instructions
11.1. Disassembly of PC (Refrigera-
tor Compartment)
11.1.1. LED board (PCB) inside the room
1. Pry off the LED lamp cover in the direction of the arrow in
a little small (-) screwdriver.
NOTES
• Be careful not to make a scratch by screwdriver (-) on
the surface of PC room.
• Please put a tape on the part where a screwdriver (-)
touch, to prevent being damaged on the inner surface.
2. Take the LED board out from the hooks (two).
3. Pull the connector of LED board out while pressing the
connector like the figure, it's possible to remove.
NOTES
• Be careful not to break LED board when it is removed
and installed.
11.1.2. Duct PC and Ag Filter board
1. Pry off and remove the Cap PC Duct (×3) by (-) screw-
driver.
2. Remove the fixed screws (three) in a (+) screwdriver,
then remove the Duct PC.
To Next Page
Loading...
