for water supply tank (P. 17)
A set of adjustment plates (P. 6)
To set the operation lock
■
To prevent tampering and incorrect operation, you can set operations not to be performed when the buttons
are pressed.
●
If any button is pressed while the operation lock is set,
“
CL
”
is displayed on the notice indicator area.
●
To cancel the setting, perform the procedure above in the same way.
●
In a case of a blackout or the power plug is disconnected, the temperature setting will reset to
“
1
”
of
the three level setting ;
“
1
”
,
“
2
”
and
“
3
”
.
①
Press the button, and then press the button to make flash.
②
Press the button to confirm “FREEZER.” ( turns on.)
③
Press the button to make flash.
④
Press and hold the button for at least 10 seconds. (A beep sounds.)
⑤
Press the or button to make adjustments.
(Display the desired level and then press the button. A beep sounds and the setting is completed.
After a short time, the indicator turns off.)
Each press of the button increases the setting by one level. Each press of the button decreases
the setting by one level.
In steps
① - ②
above, set so that flashes instead of , then set.
Perform the same steps as in
③ - ⑤
.
Perform the same steps as in
① - ④
above.
(To cancel the setting, make turn on during the step
③
.)
Simultaneously press the
and buttons
for at least 3 seconds.
A beep sounds,
“
CL
”
is displayed on the notice
indicator area, and the setting is completed.
(After a short time, the
“
CL
”
indication turns off.)
For the freezer compartment (ECO NAVI does not operate when the temperature is adjusted in detail.)
For the refrigerator compartment
Notice
Setting to suit your preferences
the refrigerator compartment door.
s volume is based on IEC 62552.