8
Operation
● Normally, the indicators are off to save electricity.
• When the power is turned on, all the function display lights will flash for 4 seconds .
The
temperature display area flashes to show the temperatures of the refrigerator compartment and the freezer
compartment, and the AG CLEAN icon lights up.
■
Adjust the temperature
Normally, use the refrigerator with the temperature set to
“
2
”
.
The temperature can be adjusted, however, if you desire to change the chilling condition.
(If the temperature control of the freezer compartment or refrigerator compartment is
set to other than
“
2
”
, ECO NAVI operation stops.)
(These are rough indications for when the ambient temperature is 30
℃
, there is no food in the refrigerator,
and the interior temperatures have stabilized. The temperatures may differ depending on the ambient
temperature, food storage state, door opening/closing, and other usage conditions.)
Approximately 2
℃
to 3
℃
lower than
“
2
”
Approximately
－
18
℃
to
－
20
℃
Approximately 2
℃
to 3
℃
higher than
“
2
”
FREEZERDisplay
Approximately 2
℃
to 3
℃
lower than
“
2
”
Approximately 3
℃
to 5
℃
Approximately 2
℃
to 3
℃
higher than
“
2
”
If no operation is performed for approximately 10 seconds when a se
tting is being changed,
the indicators turn off.
If they turn off, perform the setting operation again from the beginning.
Select
“
FREEZER
”
or
“
FRIDGE
”
.
【
FREEZER
】 【
FRIDGE
】
①
Press the button.
②
Press the button to make
or flash.
●
Settings can only be changed when the refrigerator compartment doors are closed.
Procedure Display
③
Press the button to confirm
or .
④
Press the or button to make the desired
indicator flash.
(The indicator that flashes changes with each press.)
⑤
Press the button. A beep sounds and
the setting is completed.
(After a short time, the indicator turns off.)
Notices
FRIDGE
Change the item to the desired setting.
How to view and operate the Control panel
Notification display
A
g Clean
A
lways on during
Ag Clean
Auto ice off
Always on during
Auto ice off
Compartment selection button
When setting the temperature, it is used to select the refrigerator
compartment or the freezer compartment.
Function selection button
It is used to select the required function
Set button / unlock button
Set the temperature value and set or release the function. Press
and hold for 3 seconds to unlock.
Eco navil light signal
Cooling power standard
Cooling power standard for displaying refrigerators
(compressor operating state)
Display the temperature settings of the refrigerator
compartment and the freezer compartment
Quick freezing
Always on during quick freezing
Holiday
Always on during holiday
Eco
Always on during eco
Enfocus Software - Customer Support
To Next Page
Loading...
