Step 4: Decide the position to x the Water Filter.
Determine the length of tubing that can be connected from the xing position of
Water Filter to the location of water supply, it's called “Tube A” (Refer to Figure 2).
Cutting tube surface should be flat and perpendicular with the length of tubing to
prevent water leaks.
※ Before cutting
※ After cutting
Figure 2: Decide position of Water Filter and cutting “Tube A” to connect Dual Check Valve
with water supply.
Water Filter after connected with
200 mm Tube and Dual Check Valve.
Fix the position of Water Filter.
Tube A - Cutting from 4 m white Tube of Dual
Check Valve Assembly Block to connect Dual
Check Valve with water supply.
4 m white Tube
13
To Next Page
Loading...
