※
After Water Connection System installation
● Check all connections carefully to prevent leaks.
● Switch on your refrigerator after nishing Water Connection installation.
● Allow at least 4 hours in continuous running for the refrigerator to cool down, in the
condition of no loads inside and the doors are not opened.
● For the rst time using Auto Ice making, please check the operation of Auto Ice O
mode (Page 32).
If Auto Ice O mode is in operation, turn o this mode.
Activate Auto Ice Clean mode as the instruction in Page 32 to ensure cleaning dust and
eliminate unpleasant smell.
● The rst time you use your Water Dispenser, there will be a 1 - 2 minute delay while the
tank lls. Please dispense continuously in about 30 seconds each time.
Run through and discard the rst approximately 3 liters (3 qt) of water, stopping
intermittently to remove trapped air in the system.
Failure to do this will result in excessive dripping from your dispenser.
● If the Step 6 flushing the Water Filter of trapped air (Page 15) was skipped, please
follow these below steps in the rst time using Water Dispenser to avoid water dripping:
1 Press the Water Dispenser to dispense 4 liters (4 qt) of water.
2 Wait for 3 ~ 5 minutes before dispensing again.
3 Dispense 4 liters (4 qt) of water then wait another 3 ~ 5 minutes.
4 Dispense another 4 liters (4 qt) of water. Your Water Dispenser is ready to use.
● Please note that after a few days once installation is completed, a few drops may appear
from the dispenser as the remaining trapped air is cleared.
● Water Dispenser is set for water to flow out in about 1 second delay to prevent water
from flowing out when accidentally touching the lever of Water Dispenser.
17
To Next Page
Loading...
