- 6 -
4. DISPLAY SPECIFICATION
NR-CY54AG, NR-CY557G
PROCESS INSPECTION DISPLAY
Quick Freezing
Freezer Control
ECONAVI
INVERTER
Freezer Control button
Quick Freezing button
IN-PROCESS INSPECTION
START
CONDITION
Operate the following controls within 3 sec., within 30 sec., after power-on
while PC and FC door are open.
QUICK FREEZING BUTTON ➝ FREEZER CONTROL BUTTON ➝ QUICK
FREEZING BUTTON
END
CONDITION
1 Hold down QUICK FREEZING BUTTON for over a second.
(Manual defrost)
2 After 4 hours (Defrost start)
CONTENTS
FOR CONTROL
COMP : R 6 (62rps)
FC FAN : VF4 (Ultrahigh Speed)
HEATER : DEFROST HEATER OFF
LED : ECONAVI LED and FREEZER LED [ NORMAL ]
BRINKING (ON_1sec/OFF_1sec)
MANUAL DEFROST Hold down QUICK FREEZING BUTTON for over a sec.
AUTOGNOSIS During in-process inspection.
JUDGEMENT Indicate AUTOGNOSIS in which case abnormal condition.
NOISE MODE For 45 sec., of the start of IN-PROCESS INSPECTION
CONTENTS COMP : R 7 (71rps)
INSPECTION OF TEMP. For 30 min., of the start of IN-PROCESS INSPECTION
JUDGEMENT Normal or abnormality is displayed according to the range of drop of FCC
ALL FREEZER LED LIGHTING..........GOOD
ALL FREEZER LED BRINKING..........BAD
INSPECTION OF
ILLUMINANCE SENSOR
During IN-PROCESS INSPECTION
JUDGEMENT After 1 min., of the start of IN-PROCESS INSPECTION.
Abnormality is judged according to variation width of input voltage of
illuminance sensor.
ECONAVI LED EXTINCTION..........GOOD
ECONAVI LED LIGHTING...............BAD
NR-CY54AG_CY557G.indd 6NR-CY54AG_CY557G.indd 6 6/27/2559 BE 4:44 PM6/27/2559 BE 4:44 PM
To Next Page
Loading...
