Panasonic NV-D48 Series - Timer Recording

TIMER RECORDING BY USING THE DIGITAL SCANNER (CONT’D)
For Everyweek Recording
© Turn on the Digital Scanner and trace the "CHANNEL”
bar code.
(2) Trace the bar code for the desired day of the week
among the "EVERYWEEK” bar codes.
EVERY WEEK
@ Trace the "START TIME” and then the "END TIME"
bar codes, and transmit the data to the VTR.
•Everyweek recording will be performed from that week on.
•If a “DATE” bar code is traced after tracing the "EVERY¬
WEEK” bar code, everyweek recording will not be
performed.
To Confirm the Programme of a Timer Recoring
To perform this operation, the VTR must be turned on or it
must be in the timer recording standby mode (B indication
is lit).
O Trace the "CHECK” bar code.
o Perform transmission.
•After releasing the Transmit Button, the programmed
data will be displayed for about 8 seconds (for about
25 seconds, if the B indication is not lit) on the
Multi-Function Display.
•At every push of the Transmit Button, the timer
programme number advances to the ne>t higher
number.
To Cancel a Programmed Timer Recording
To perform this operation, the VTR must be turned on but
not be in any of the recording or playback operation modes,
or it must be in the timer recording standby mode ( □
indication is lit). To cancel a programmed timer recording,
Its data must be displayed on the Multi-Function Display, If
they are no longer displayed, first, trace the "CHECK” bar
code and perform transmission (several times, if necessary,
until the programme you want to cancel is displayed).
Then, within 8 seconds (within 25 seconds, if the □
indication is not lit):
© Trace the "CANCEL” bar code.
Perform transmission.
•To programme a new timer recording, perform the
programming from the beginning.
22