Panasonic NV-D48 Series - Infra-Red Remote Controller and Digital Scanner

INFRA-RED REMOTE CONTROLLER AND
DIGITAL SCANNER
Part Number: VEQ0719
O VTR On/Off Button
Q Memory/Search Button
0 Reaet/Index Button
O Programme Position (Channel) Selector Buttons
select channel press button
1-9 □ —E respective channel
10 CH
20 [E]-»[I]-*C^
(T) Transmit Button
Bar Code Reading Section
Digital Scanner On/Off Switch
Bar Code Reader Display
11-32
for example 32
E]-*CI]-*[ZI
If more than 5 seconds pass between the first, second and
third push, the channel will not be changed normally
0 Record Buttons (•)
@ Pause/Still Button (II)
Q Rewind '^ ■ ^/Revlew @ Button
^ Slow Buttons
0 Reverse Play Button
0 Digital Function Buttons
0 Intro Scan Button
0 Double Speed Playback Button (x2)
0 Fast Forward ►► /Cue Q Button
0 Play Button ( ► )
0 Still Advance Button (!! ► )
0 Stop Button ( ■ )
0 Time Search Button
0 +/— Button
0 VTRH'V Selector
O Display
0 Start Time Display
0 End Time Display
0 Channel Display
0 Check Indicator
(5) Transmitting Section
How to Operate the Digital Scanner
Set the Digital Scanner On/Off Switch to “ON”.
•If no operation is performed for more than 25 seconds, the
scanner will automatically switch over to the power-saving
standby condition and the lamp will go off. (In this case, if
bar codes have already been read but not yet transmitted
to the VTR, the data will be cancelled.)
•When the Digital Scanner On/Off Switch is set to “ON”
but the lamp is not lit, set the switch to “OFF” and then to
“ON” again.
6