Panasonic NV-HD670 Series - G-Code Programming Setup

Preparations
for
G-Code
Programming
Identification numbers must be set for G-Code
programming. Proceed with the G-Code programming
operation described on page 29, and the identification
numbers of the TV stations concerned will be set
automatically. This will allow G-Code programming to be
undertaken without performing the operation described on
this page. However, you can follow the setting procedure
described below if you wish to set the identification
numbers of all the TV stations prior to actual programming.
“\dentification numbers’ refer to the numbers used for
identifying TV stations.
The programme positions on the VCR receiving the TV
stations are set in these identification numbers.
Have a newspaper or magazine which lists today’s local
TV station programmes and G-Code numbers on hand.
Preparations
*Set the clock of the VCR. See page 16.
*Store TV broadcasts in your VCR. See pages 11-13.
©Confirm that the TV is on and the VCR viewing channel
is selected.
®Turn on the VCR.
Press VCR/TV to select the VCR mode.
(NV-HD670EA only)
Ol.;
vy
F
Operations On Screen Display
4 Press MENU. Ss
"ARES D>
sacepe set &
papeayicheae i
Y)
Select G-CODE CH SET.
Po oso meng |
LANGUAGE
ENTER GLocK ser.
CB Gi Cc) ‘OPTION
DEMONSTRATION
SELECT: :DO,ENTER
END :MENU
Select the identification number
(GUIDE CH) (001-255).
|
GUIDE, GH, cH
ton - =e
‘SELECT:00 00
END:MENU
4
Press «€ or ® then select the
programme position (1-99, A1 or A2). |
G-CODE CH SET
QUIDE CH Gu,
SELECT: =a
ENO:MENU
To set the other TV stations, press <4 or ® then
repeat steps 3 and 4,
5
Press MENU twice.
Note:
To receive satellite stations, the satellite receiver must be
connected to the VCR and programme position must be
set depending on the type of connection.
A1/A2: When the satellite receiver is connected to the
audio/video input sockets (AV1/AV2).
When the satellite receiver is connected by means of the
RF coaxial cable, set to a free programme position
between 1 and 99.
OC CO
Oo
e© 8,0! @'0}
17