8mm
min. 0.9mm
Gap for removing (D-cut)
Blindfold cap
3. How to remove the blindfold cap
a flat-bladed screwdriver
a blindfold cap
1. Prepare a flat-bladed screwdriver which can
be inserted in the gap for removing
2. Insert this flat-bladed screwdriver in the gap(D-cut ).
3. Remove a blindfold cap
Gap(D-cut)
2. Specification of a blindfold cap
Blindfold cap
Notes when caps are assembled in the rear cover
1. Position of D-cut : Lower (Refer to above photo)
2. The surface of the cap must be flush with the rear cover.
Service Information (Blindfold Cap of Screw)
86
The FZ series use the blindfold caps of the screws on the rear cover for 360 degree viewing design.
To remove these caps from the rear cover, a flat-bladed screwdriver is necessary.
OLED
65inch FZ series
1. Number of use and Use position
Number of Blindfold cap : N=12
55inch FZ series
Number of Blindfold cap : N=10
To Next Page
Loading...
