Panasonic Omnivision PV-8450 - Tape Operation; Program Index Search; Index Scan

Important for Program Index Search:
Timer recordings must be
recorded back to back in order for
them to be placed on the Program
Index list. If a timer recording Is
followed by a function, such as
REW or PLAY, the data is lost.
STOP/EJECT
REWIND FAST FORWARD
C C
Program Index Search
(For timer recordings only)
This feature allows you to choose a timer recorded program from a
Program Index list and then start a search for that program.
Once the tape is ejected or normal recording is started,
all program Index data are deleted.
1 Press INDEX to display the “SELE<
SEARCH MODE” screen.
2 Press AT to select “PROGRAM
INDEX SEARCH,” and then press
to display the “PROGRAM INDEX"
screen.
3 Press AT to select the desired
recorded program, and then
press ► to start the forward or
rewind search.
• When the designated program is reached,
the VCR goes into Playback mode.
Index Scan
(For normai and/or timer recordings)
This feature allows you to scan (fonvard or reverse)
each recording for 10 seconds in Playback mode.
d Press INDEX to display the
“SELECT SEARCH MODE” screen.
• This screen appears only if there are timer
recordinas on the Program Index list. If this
screen does not appear, go to step c.
b Press AT to select “INDEX
SEARCH," and then press ►
to display the “INDEX” screen.
C Press REW or FF to begin the scan.
• As each index mark is reached,
a short playback will be performed
after which FF or REW resumes.
d Press PLAY to cancel the scan
and begin playback.
• You may also press STOP to stop the tape.
start here
25
More
You
Can
Do