Panasonic Omnivision PV-8450 - Copying Your Tapes (Dubbing) (Connection, Main Operation, Monitoring, Select Input Mode)

Copyin^iburT^ge^Dubbiiig^
Connections you’ll need to make.
• When connecting to a normal VCR, use the L Audio In jack for proper sound reproduction.
Playing (Source) VCR Recording (Editing) VCR TV for Monitoring
1 Insert a pre-recorded
tape into the Playing
(Source) VCR.
To Monitor Dubbing on Your TV
1 Turn your TV on and tune to the Recording
VCR channel (CH3 or CH4).
2 Insert a blank tape with
record tab Into the
Recording (Editing) VCR.
3 S elect "LINE” Input mode on the
Recording (Editing) VCR. (See “Selecting
the Input Mode” at right.)
4 P ress PLAY on the Playing VCR.
Press PAUSE at the desired starting point.
5 P ress REC on the Recording VCR, and then
press PAUSE immediately thereafter.
6 P ress PAUSE on both VCRs at the same
time, t o begin copying.
To Edit Out Unwanted Parts
Press PAUSE on the recording VCR while copying is
in progress. Press PAUSE again to resume copying.
7 Press STOP on both VCRs to stop copying.
2 Set the VCR/TV Selector on the Recording
VCR to “VCR.”
Selecting the Input Mode
Press INPUT.
The display will change in the order below.
C Channel
Number
♦ ► L INE
or
Press CH A/T.
The display will change in the order below.
• When LINE is selected, “L” is displayed in the Multi
Function Display for about 4 seconds.
Caution:
Unauthorized exchanging and/or copying of copyrighted
recordings may be copyright infringement.
30