Search System is .,.
Each time a recording is made, an invisibleindex mark is placed on the tape. When timer recordings are
made, program index and information are also included. These index marks can be used to access or
scan recordings.
Go directly to the desired recording.
1
Press SEARCH in
Playback or Stop
mode to display
INDEX SEARCH
screen, and then
press number keys
to select the recording
number.
• To calculate number, see
below.
Press FF or REW to
sta_ search.
2
Play begins at
search end.
To search forward
or back 1 index,
press FF or REW
while screen
left in displayed
(10 sec.).
TO cancel, press
PLAY.
• To calculate the Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
Example 2:
To goto rec.6 from rec.2, enter4 and pressFF.
NOTE: _,indicates start points of each recording.
FF
REW
• Make each entry within 1O seconds, or the Index Search
mode wlll be canceled.
• If index Search is started very close to an index mark, that
index mark may not be counted in the search.
To Next Page
Loading...
