Panasonic OmniVision PV-C2020 User Manual

fp DT START STOP CH SPD
|1 day 9:OOp 12:00a 06 SP|
CANCEL:ADD/DLT KEY
SELECT 1-8: A Y KEY
ENTER : ► KEY
END :PROG/ACT I ON KEY
___
End the program.
Prp<;<?
9 PROG/VCR+
q&P (or ACTION.)
To Enter More Programs
Press AT and ► to select and
set a blank program number,
and then repeat steps 3 and 4.
Exit this mode.
Press PROG/VCR+
(or ACTION) twice.
• It you’re using a cable box, make
sure that it is turned to the desired
channel and the power is left on for
timer recording.
• PROG TIMER indicator lights on
the unit.
Review, Replace or Clear Program
Contents : (Recording is not in progress)
Q, Repeat steps 1 and 2 on page 14.
P DT START STOP CH SPD
2 8 10:00at2:00p125 SP
3 10 8:OOp 9:00p 10 SP
4 SU 9:OOp10:OOp L LP
CANCEL:ADD/DLT KEY
SELECT 1-8: a Y KEY
ENTER > KEY
END :PROG/ACT I ON KEY
Select the desired
program.
Press AT to
select.
To Replace program...
SATE \j START STOP CH
8 SAT 9:Q0P 12:Q0A Q8
YOb/OfX ABC
CATEGORY:MOV IE SP
NOTES:STAND BY ME
[SELECT START DATE I
SELECT: A Y KEY
SET : ■ * ► KEY
END :PROG/ACTION KEY
___ >
1) Press ► t o
display.
2) Press AT to
select and or
^ to set new
program contents.
3) Press
PROG/VCR+
(or ACTION.)
To Clear program...
P DT START STOP CH
SPD
2 8 10:00pl2:00a125 SP
3 10 8:OOp 9:OOp 10 SP
4 SU 9:OOpIO:OOp L LP
SELECT 1-8:A Y KEY
ENTER : ► KEY
[ END
:PROG/ACT ION KEY
ADD/DLT
Press ADD/DLT.
Exit this mode.
Press PROG/VCR+
(or ACTION) twice.
i
Cancel a Timer
Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cancel the Timer Recording.
• Any future daily or weekly recordings
will be performed as prog rammed.
v_/
*o m
GO CD CDj
GO CD CD?
GO CD CD
CD CD G5M
HEW- PlAV FE “
GD CED GD
feJW CUSMf STOP StAflOt
CD O CD-©—Hj— STOP
Tape vttOcaprrin RfC
B O □ 0
PQS*tTC«< HEXT_
b SET
* SELECT
C ^:CH UP
▼ :CH DOWN
► :VOL UP
◄ :VOL DOWN
c
«
X d p R O G/VCR+
-C ADD/DLT
15
Advanced
Operation

Panasonic OmniVision PV-C2020 Specifications

General

Brand	Panasonic
Model	OmniVision PV-C2020
Category	VCR
Language	English