Panasonic OmniVision PV-C2020 - Cable Box Setup.17

Cable Box Setup
Process of Recording
Connection
o
o
Programming
1
Display MAIN MENU.
Press ACTION.
MAIN MENU
Pig
VCTT
LANGUAGE
o
ch clock Exit
SELECT KEY
SET :ACT I ON KEY
Display SET UP CH
screen.
1) Press AW<>
to select “CH.”
2) Press ACTION
to display.
SET UP CHANNEL
ANTENNA : CABLE
AUTO SET
CHANNEL CAPTION
WEAK SIGNAL 01 SPLAY:OFF
- ■ swa —
' lus+
SELECT:A ▼ KEY
SET : ► KEY
END :ACT I ON KEY
Select CABLE BOX
SET UP.
1) Press AW to
select.
2) Press ►
to display.
ARE YOU USING
A CABLE BOX?
YES
LV«1
SELECT :A ▼ KEY
SET > KEY
END :ACTI ON KEY
Select “YES” or “NO.”
1) Press AW to
select "YES”
or “NO.”
2) Press ► to set.
If you select...
■ “YES”-> Step 5.
■ “NO” -» Press ACTION -* Go to VCR Plus* Channel
Setup on page 18.
5 ENTER CABLE BOX OUTPUT
CHANNEL
EH
SELECT : A t KEY
SET : ► KEY
END :ACTION KEY
Select Cable Box output
channel number.
1) Press AW to
select.
2) Press ►
to enter.
• If necessary, refer to your cable
box manual.
• If you are using Audio/Video jack
connection for your cable box,
select and set “VIDEO OUT” as
the output channel.
2
* SELECT/
3 SET
* a;CH UP
4 ▼ : CH DOWN
* ► :VOL UP
O i :VOL DOWN
1 ACTION
2
/-\
VCR Plus+and PlusCode are registered
trademarks of Gemstar Development
Corporation.
The VCR Plus+system is manufactured
under license from Gemstar Development
Corporation.
_ J
17
Advanced
Operation