Panasonic OmniVision PV-C2020 User Manual

Direct Access (For Normal and/or Timer recordings)
Go directly to the desired recording.
Display SELECT
SEARCH MODE screen.
Press SEARCH in
Playback or Stop mode.
• If there are no Timer
Recordings on the Program
Index List, go to step 3.
Display INDEX screen.
1) Press AT
to select
“INDEX
SEARCH.”
2) Press ► to
display.
• This screen appears only if
there are Timer Recordings.
Select the recording
number.
Prpco
NUMBERED
keys.
• To calculate number, see below.
To calculate the Index Number
Example 1:
If you are watching recording 4 and you want to watch
recording 2, enter 3 in step “3” and press REW.
Example 2:
If you are watching recording 2 and you want to watch
recording 6, enter 4 in step “3" and press FF.
NOTE: | indicates start points of each recording.
28
VHS Index Search System is ...
Each time recording is made, an invisible
index mark is placed on the tape. When
timer recordings are made, program
index and information are also included.
These index marks can be used to
access or scan recordings.
4 REW 4fF
SET
SELECT
^:CH UP
▼ : CH DOWN
► :VOL UP
NUMBERED
Key
REW/FF
SEARCH
• Make each entry within 10 seconds, or
the Index Search mode will be canceled.
• If these VHS Index Search Systems are
started very close to an index mark, that
index mark may not be counted in the
search.
For assistance, call 1 -800-211-PANA(7262)

Panasonic OmniVision PV-C2020 Specifications

General

Brand	Panasonic
Model	OmniVision PV-C2020
Category	VCR
Language	English