Go directly to the desired recording,
r
i SEARCH
L o
Display SELECT
SEARCH MODE screen.
Press SEARCH* in
Playback or Stop mode.
• If there are no Timer
Recordingsonthe Program
IndexList,gotostep 3.
SELECT SEARCH MODE l [
=ZERO SEARCH
PROGRAM END SEARCH
PROGRAM INDEX SEARCH _ '
SELECT:& • KEY
SET :, KEY
_HKEY
Display INDEX screen.
1) Press &T
to select
"INDEX
SEARCH."
2) Press 1_to
display.
• This screen appearsonlyif
thereare TimerRecordings.
31
INDEX
Select the recording
number.
Press
_ _ NUMBERED
_ _ keys.
• To calculate number, see below.
_NDEX SEARCH O4
Start search.
Press FF or REW.
FF{_]
• Whensearch is
finished, playback
begins.
or
REW_
To calculate the Index Number
Example 1 :
If you are watching recording 4 and you want to watch
recording 2, enter 3 in step "3" and press REW.
171
Example 2:
If you are watching recording 2 and you want to watch
recording 6, enter 4 in step "3" and press FF.
NOTE: J. indicates start points of each recording.
26
VHS Index Search System is ...
Each time recording is made, an invisible
index mark is placed on the tape. When
timer recordings are made, program
index and information are also included.
These index marks can be used to
access or scan recordings.
Model PV-C2060 unit is shown here.
r
SET
CT
A:CH UP
v:CH DOWN
t,:VOL UP
3 NUMBERED
Key
!FF or REW
SEARCH
• Make each entry within 10 seconds, or
the Index Search mode will be canceled.
• If these VHS Index Search Systems are
started very close to an index mark, that
index mark may not be counted in the
search.
To Next Page
Loading...
