This unit writes program data (see example below) for about the first 10
seconds of every recording.
The information is then displayed the first 10 seconds of playback. To
change the data, see "Changing Time Stamp Data" section on next page.
Press ACTION*.
2
MAIN MENU
SELECT:I • • • KEY
SET :ACTION KEY
Display SET UP VCR
screen•
_'_)i t)Press l_'<I"
, to select
"VCR."
2) Press ACTION
ii _O to display•
IIIAIII._jlT UP VCR
REPEAT PLAY : OFF
TIMER PROGRAMMING
REMOTE WARNING ON I
SELECT:& • KEY
END :ACTION KEY
SET :• KEY
Select TIME STAMP.
. 1) Press A.V to
,_, select.
2) Press • to set
L_ "ON" or "OFF."
• When "OFF" is selected, the
program data is written on the
tape, but will not be displayed.
4
Return to normal
screen,
Press ACTION twice.
<Time Stamp Example >
Normal/One
Touch Recording
Timer
Recording
When Clock
is not set...
[_Check list before you begin.
[] The clock is set to correct time.
[] The record tab is in place.
m EJECT LIGHI
@@®
Q®®
I
moe,_T
p_E ua p sop _L_y
2 SET
"- SELECT
_,,_A:CH UP
v:CH DOWN
_,:VOL UP
4 :VOL DOWN
1ACTION
To Next Page
Loading...
