Panasonic OmniVision PV-C2060

DISPLAY=_ I To display or remove the
;overlay.
Press DISPLAY.
Rec Time Remaining
(OTR
page 13.)
Receivabl
Types (See page 11.)
Function Status Channel Caption
Currint Time
REC 12:OOPM ABI !
- _S25REO÷ -o:,2:3_ --Counter
_'s_P° _mape Speed
Time Stamp Data (See pages 30, 31.)
Whenever a blank section of a tape
comes up in Play mode, or when the
selected channel has no broadcast
signal with the "Weak Signal Display
ON/OFF" (see page 32) set to "OFF,"
the TV screen will turn solid blue.
When a function button is pressed
(PLAY, FF, etc.) or you change channels,
the unit mode or channel number will be
displayed.
(Some station names may also appear if
Channel Caption is set. See pages 28, 29.)
08
ABC
Warning and Instruction Displays These dispJayswilnalert you of a missed
operation or provide further instructions,
NO CH FOUND PLEASE CHECK • If no active channels are found for CHANNEL MEMORY...
ANTENNA CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
PLEASE SET CLOCK BEFORE
PROGRAMMING
CHECK CASSEttE RECORD TAB
TO CANCEL TIMER REC HOLD DOWN
STOP KEY FOR APPROX 3 SEC
• If you attempt to set or review a Timer Recording, VCR Plus+
System Programming or set the On-Timer and the Clock is not set...
• Ifyou press REC, and a cassette is inserted with no record tab...
• Ifyou press STOP during a Timer Recording...
NO CASSETTE
PLEASE INSERT A CASSETrE
• Ifyou press PLAY, FF, REW, or REC without a cassette inserted...
REMOTE CONTROL IS SET
TO DSSICABLE MODE
USE COMBO : COMBO KEY
• Ifyou press POWER, ACTION, or PROG on the remote while in
DSS or CABLE mode...
VIDEO HEADS MAY NEED CLEANING
PLEASE INSERT HEAD CLEANING
CASSETTE OR REFER TO MANUAL
END: PLAY KEY
• If head cleaning becomes necessary while playing back a tape...
VCR LOCK ACTIVATED
• Ifyou press a function button other than STOP/EJECT or POWER
while the unit is in VCR Lock mode...
8,9,46
6,13
15
12,13
42,43
48
32
47