Panasonic Omnivision PVQ-V200 User Manual

Important: If the remote control POWER, ACTION, PROGA/CR+, CH A/v, NUMBERED keys,
INPUT, SEARCH or ADD/DLT button does not work when pressed, press the
VCR button on the remote and try the button again.
Check list before you begin.
O The clock is set.
□ VCR Plus+ System Setup is complete (see pages 14-16).
VCR Plus+System Programming
Process of Recording
Connection
Setup
Display SET PROGRAM.
Press PROGA/CR+.*
2
SET PROGRAM
VCR Ptus+ PROGRAMMING
TIMER PROGRAMMING
SELECT;A ▼ KEY
SET ; ► KEY
END :PROG KEY
Display VCR Plus+
screen.
1) Press AT
to select.
2) Press ►
to display.
3
VCR PIUS+ SYSTEM
ENTER PLUSCODE NUMBER
s /
/ \
USING 0-9 KEYS
To Make Corrections,
press 4 repeatedly 1o delete the
PlusCode programming number.
VCR PIUS+ SYSTEM
DAILY(MON-FRI)
WEEKLY
SELECT;A ▼ KEY
SET : ► KEY
END ;PR0G KEY
Enter PlusCode
programming number.
1) Press
Numbered
keys.
2) Press PROG/
VCR+ to lock
in the program.
Enter record frequency.
1) Press AT to
select.
2) Press ► to set.
OiSPUr TAP€ PQS.\0N
O CD O
tUMP ZntO SiARCH.
CD O O O-i
SUW
dB
CD (Di
va CH 5|
6 POWER
P SELECT/
.SET
3 A PLAY
T :STOP
; ◄ :REW
4 ► :FF
PROG/
VCR+
5 ACTION
'3 NUMBERED
keys
ADD/
DELETE
Model PV*V4520 remote is shown
here.
Select re cord speed.
1) Press AV to
change.
2) Press ► to set.
5
6
P OT START STOP CH SPD
1 PAY 9;00A12:00A 08 SP
3 - ; - — —
4 - - - ; - - -
CANCEL;ADD/DLT KEY
SELECT 1-8: A T KEY
ENTER : ► KEY
END ;PROG/ACT I ON KEY
^TIMER-
/ I
Multi Function Display
End programming.
1) Press PROG/
VCR+ (or ACTION).
/^(VG I To cancel
I press ADD/DLT.
2) Press PROG/
VCR+ (or ACTION)
again to exit.
Use normal Timer Recording steps If:
• the PlusCode programming number for a
program is not listed.
• you anticipate the program, such as a
sporting event, to run over the scheduled
stop time.
See page 13 to:
• cancel a timer recording in progress.
• replace program contents.
• review or clear program contents once set.
Important notes for OSS/Cable Box users
• When recording via DSS, the receiver,
must be left on.
• When recording via cable or antenna,
DSS receiver must be off.
Set timer.
Press POWER off.
Avoid overlapping program times.
VCR PlusCode programming numbers
can not be used to program the VCR to
record DSS channels.
You can obtain unlisted PlusCode
numbers by calling 1 - 900 - 454 • 7587.
Call costs approximately $.95 per minute.
17
Timer
Recording
Using
VCR
Plus+
System

Panasonic Omnivision PVQ-V200 Specifications

General

Brand	Panasonic
Model	Omnivision PVQ-V200
Category	VCR
Language	English