[_Ready Check List
[] The clock is set to correct time.
[] VCR Plus+ System Setup is
complete. (See page 26.)
Use normal Timer Recording steps if:
• a program PlusCode programming number
is not listed.
• program, such as a sporting event, may run
over scheduled stop time.
See page 25 to:
• cancel a timer recording in progress.
• replace program contents.
• review or clear program contents once set.
• You can obtain unlisted PlusCode
programming numbers by calling
1-900-454-7587.
Call costs approximately $.95 per minute.
Avoid, overlapping program times.
If you re using a cable box, make sure that
it is tuned to the desired channel and the
power is left on for timer recording.
• Timer programs memory capacity is 8.
To add more programs, please first clear
other programs. (See page 25.)
• Make each entry within 5 minutes or the
unit will leave this mode.
• Once local channels have been
programmed, they will stay in memory,
even in the case of a power failure.
VCR Plus+ and PlusCode are
registered trademarks of Gemstar
Development Corporation.
The VCR Plus+system is
manufactured under license from
Gemstar Development Corporation.
ACTION-
EJEGt LIG_-F_
O@®
(3:) QD (3Di
(D ¢E) (3D
_cD_
pAUlZ oe_2,m s_or* _LA_-
!-(D c:3 (3DSt
SELECT/
SET
A:CH UP
--v:CH DOWN
!' :VOL UP
4:VOLDOWN
-PROGNCR+
NUMBER
- Keys
--ADDIDLT
VCR Plus+ System Programming
Press PROG/VCR+
to display SET PROGRAM screen.
p [ SET PROGRAM
TIMER _NG
• H i -'w" .r,_•v _.
ONTIMER
SELECT :A •
:PP_G
1) Press J,V to select
VCR Plus+
PROGRAMMING.
2) Press • to display
screen.
3
VCR PlU_+S_STEM
ENTER PLUSCODE NUMBER
\1/
USING 0-9 KEYS
END ;FROG
1) Press number keys
toenter PlusCode
programming number.
2) Press PROG/VCR+
when finished.
To Make Corrections
Press _ repeatedly to delete
the PlusCode programming number.
4
5
VCR Plus* SYSTEM
DA I LY (MON-FR I )
_E_i_LY
1) Press AV to select
and • to set
Record Frequency.
SELECT : & •
SET : _-
END : PROS
DATE; START STOP CH
\1/ PBS
CATEGORY:N/A SP
SELECT:A •
SET :<
END :PROG/ACTION
_t/
1) Press AV to select '_':'l_,:n
and • to set
Category and
Record speed.
Selections:
• Categories ---) N/A (not applicable), SPORTS,
MOVIE, COMEDY, MUSIC, or DRAMA
• Speed "-)SP, LP, or SLP
To Make Corrections
Press • _ to move the cursor and AV to make the
correction.
6
DT START STOP CH SPD
*_ leo II. , -
CANCEL:ADD/_LT
SELECT t-8:_ •
ENTER :_
END :PROG/ACTION
Press PROG/VCR+
(or ACTION.)
to end programming.
Press PROGh/CR+ twice (or ACTION)
to exit this mode.
• PROG TIMER indicator lights on the unit.
27
To Next Page
Loading...
