The following are possible broadcast types with their accompanying
on-screen displays. The signal being received is indicated with a
" (€," mark while the selected audio mode is indicated with an arrow.
To change the audio mode for these broadcasts, follow the "Select Audio
Mode for TV Viewing" section (below.)
Display the broadcast signal
being received.
Press DISPLAY to display.
MTS Stereo and SAP broadcast
Multi-channel Television Sound Stereo
(main language) and Secondary Audio
Program (sub language) broadcasts are
both being received simultaneously.
Select the STEREO or SAP audio mode.
MTS Stereo broadcast
Multi-channel Television Sound Stereo
broadcast, Select STEREO audio mode,
• tf stereo broadcast is weak and the display
flickers, select MONO audio mode for
possibly better results.
SAP broadcast
Secondary Audio Program (sub language.)
Select SAP audio mode for the sub language.
MONO broadcast
Normal monaural sound broadcast.
< Example >
Press AUDIO to select the desired
audio mode as described above.
(Arrow shows selection,)
• Each press of AUDIO will change the audio
mode as shown betow.
• "SAP" is selected with first press of AUDIO.
I [ STOP _2:oo_ _c 1
Press o:oo:oo
_STEREO SP
Aoo,o/sA - /
MONO _- STOP 12:OOAM ABC
0:00:00
LPress _,,,._|
AUDIO _""_ L.
Equipped with ¢ll_x® -TV Noise Reduction
for true MTS reproduction.
¢n_x® -TV Noise Reduction is required for
good stereo separation and audio fidelity.
¢ll.,x® is a registered trademark, and is
licensed by _bx ® Technology Licensing.
;PLAY
AUDIO
• Only TV audio from Main Picture
is output.
• Audio mode can only be changed
for the Main Picture,
13
To Next Page
Loading...
