This unit writes program data (see example below) for about the first 10
seconds of every recording.
The information is then displayed during the first 10 seconds of playback.
To change the data, see Changng T'me Stamp Data" section on next
page.
Display MAIN MENU.
Press ACTION*.
2
MAIN MENU
_J ' ,T_
S_IJECT:& • .41ip- KEY
SET :ACTION KEY
Display SET UP VCR
screen.
@
%
1) Press AY< I_
to select
"VCR."
2) Press ACTION
to display.
3
4
SET UP VCR
:IEPEAT PLAY : OFF
TIMER pROGRAMMING
REMOTE WARNING
SELECT:& • KEY
SET :_ KEY
END :ACTION KEY
Select TIME STAMP.
1) Press _k,V to
select.
2) Press I_ to set
"ON" or "OFF."
• When "OFF" is selected, the
program data is written on the
tape, but will not be displayed.
%
Return to normal
screen.
Press ACTION twice.
<Time Stamp Example >
Normal/One
Touch Recording
Timer
Recording
[_tCheck listbefore you begin.
[] The clock is set to correct time.
[] The record tab is in place.
SELECT/
3--:CHUP
v:CH DOWN
1_:VOL UP
<:VOL DOWN
1ACTION
When Clock
is not set...
To Next Page
Loading...
