Do "Preset Caption" steps 1-3 (page 30.)
2
CHANNEL CAPTION
PRESET CAPTION
SELECT:& • KEY
SET :b KEY
END :ACTION KEY
Select MANUAL
CAPTION.
1) Press.V
to select.2) Press l_to
display.
3
MANUAL CAPTION
CR NUMBER CAPTION
SELECTtA • KEY
SET :_ KEY
ENO :ACTION KEY
Select Channel
number.
I@
1) Press AV
to select CH
NUMBER.
2) Press I_ to
move cursor
to the right.
• Channels already set and
channels deleted from Channel
Memory are not displayed.
• You can set a total of ten channel
captions with up to four
characters each,
4
MANUAL CAPTION
ON NUMeER CAPTION
02 _---
CLEAR :A00/DLT KEY
SELECT:& • KEY
SET :4 _ KEY
END :ACTION KEY
Enter your caption.
1) Press AY
to select.
2) Press I_ to
enter.
• Characters change in
the following order.
_A--B--C ...... Z-- BLANK-- -- --&_]
• 9 ...... 2--1--0--/ !'_--
• Press • repeatedly to move the
cursor to "CH NUMBER." Repeat
steps 3 and 4 as desired.
To Make Corrections
Press AV, then I_ to select channel number.
Press AV to change, or ADD/DLT to delete.
%
I End setup.
i Press ACTION four times.
SELECT/
SET
3-:cHuP
• v:CH DOWN
4, _ :VOL UP
:VOL DOWN
-5 ACTION
--ADDIDLT
31