Panasonic Omnivision VHS PV-C2780 - Page 21

Process of Recording
IConnection I _" _ _:'__
(_j Display SET PROGRAM
screen,
Press PROG/VCR+.
PROGRAMMING.
T,,,'_ F_C_'4'.,_,'_S ] _ 1) Press AV to
o__.,_R select.
_iECT _(_. 2) Press I_ todisplay.
3
VCR P;;_- SYSTEM
ENTER PLUSCODE ,_;U!.!BER
\l/
/l\
USING 0-9 KEYS
END : _ KEY
Enter PlusCode
programming number.
To Make Corrections
(Z) G) _)
G) G) _)
(D G) G)
G)
1) Press
NUMBERED
keys.
2) Press
PROG/VCR+
when finished.
Press _1 repeatedly to delete the PlusCode programming number.
4
VCR Pk*s÷ SYSTEM
OA i LY (MO_-FR I )
=%EEKLY
SELECT:• • KEY
SET I_ KEY
END : _G KEY
Set Record Frequency.
1) Press AV to
select.
2) Press I_ to set.
[_Check list before you begin.
[] The clock is set to correct time.
[] VCR Plus+ System Setup iscomplete.
(See pages 19, 20.)
_SELECT/
4_:CH UP
• _:CH DOWN
i
5 !_:VOL UP
_1:VOL DOWN
1
7
NUMBERED
Keys
OATE STAeT STOP CR] Set Category and
__ Record speed.
CATEGORY" N_A/ PBpS] . If wanted, make a note (see page 16.)
J_ ......... J -- 1) PressAVto
S_EC_:: : _[_ a _ select.
I END :_RCO ACTION KEY / _ "\L _/'1 _. _ =.- . •
...... , _ z) I-'ress _ to set.
Select desired type:
• Categories .--) N/A (not applicable), SPORTS, MOVIE, COMEDY
MUSIC, or DRAMA
• Speed -.) SP, LP, or SLP
To Make Corrections
Press _1 • to move the cursor and AV to make the correction.
Use normal Timer Recording steps if:
• a program PlusCode programming
number is not listed.
• program, such as a sporting event, may
run over scheduled stop time.
See page 17 to:
• cancel a timer recording in progress.
• replace program contents.
• review or clear program contents once set.
CANCEL AOD CLT KEY
SELECT 1-8:A • KEY
ENTER :_ KEY
END PR_'ACTION KEY
End programming.
Press
_ PROG/VCR+
" (or ACTION.)
Exit this mode.
Press PROGiVCR+
(or ACTION) twice.
• PROG TIMER indicator lights on
the unit.
0
• You can obtain unlisted PlusCode
programming numbers by calling 1-900-
454-7587. Call costs approximately $.95
per minute.
• Avoid overlapping program times.
• ff you're using a cable box, make sure
that it is turned to the desired channel
and the power is left on for timer
recording.
• Timer programs memory capacity is 8.
To add more programs, please first clear
other programs. (See page 17.)
21