Go directly to the desired recording.
2
3
Display SELECT
SEARCH MODE screen.
Press SEARCH* in
Playback or Stop mode.
• If there are no Timer
Recordings on the Program
Index List, go to step 3.
SELECT SEARCH MODE
ZERO SEARCH
P_M ENO SEARCH
PROGRAM INDEX SEARCH
SELECT:& • KEY
SET :_ KEY
END :SFJi, RCH KEY
Display INDEX screen.
1) Press JI,V
to select
"INDEX
SEARCH."
2) Press • to
display.
• This screen appears only if
there are Timer Recordings.
INDEX Select the recording
number.
Press
QQQ
(_ O Q NUMBERED
Q Q (_ keys.
O
VHS Index Search System is ...
Each time recording is made, an invisible
index mark is placed on the tape. When
timer recordings are made, program
index and information are also included.
These index marks can be used to
access or scan recordings.
+++++++
4RE
• To calculate number, see below.
i '"<_ o, i Start search.
x++o! lress°r+
oWhen search is
finished, playback
OF begins.
........................................ R_
To calculate the Index Number
Example 1:
If you are watching recording 4 and you want to watch
recording 2, enter 3 in step "3" and press nEW.
t,l 1 1,1,1 ,
Example 2:
If you are watching recording 2 and you want to watch
recording 6, enter 4 in step "3" and press FF.
1112 131,1,1, l,i
NOTE: _. indicates start points of each recording.
SELECT/
A:CH UP
v:CH DOWN
k :VOL UP
3 NUMBERED
Keys
SEARCH
O
• Make each entry within 10 seconds, or
the Index Search mode will be canceled.
• If these VHS Index Search Systems are
started very close to an index mark, that
index mark may not be counted in the
search.
28 I;r.] Ill:-t-l-1 kl t:.1i[_#l .]l:_-k'[:4[_.| Ill B:III|_J 1 [] "J-'l _]-*_lrJP-_.'_[.] i-'[:] I[.l:_ ill;-|l li(.H_.] l l-'l!lll[=] I *]I[.]. 1![.{ _[_ i_| i_1-'[.], I[NI*[.I! 11
To Next Page
Loading...
