Panasonic Palmcorder PalmSight PV-L658 - Page 30

Playing Back your Recordings
TV Playback or Viewing
Your Camcorder may be connected to a
TV to play back tapes or to view what you
are recording.
TV with AUDIO/VIDEO IN Jacks.
Back of TV
To Audio In
Audio/Video
Cable
(Supplied)
yy”
To Audio/Video Out
TV without AUDIO/VIDEO IN Jacks.
2
RF Adaptor
(optional) VHF Antenna
300 ohm-75 ohm
transformer
(not supplied)
or F Connector
UHF Antenna
Selector
VHF Connecting
Cable
(not supplied)
To VHF Antenna
Terminal
30
Before you begin...
e Connect the Camcorder to a power source.
1 Set the POWER switch to VCR for
tape playback.
Or, set to CAMERA to view what your
Camcorder is recording.
L. the TV ON and set it to LINE
INPUT.
Check your TV operating instructions.
Note:
If your TV has no VIDEO or AUDIO IN
jacks, select CH 3 or 4 on your TV to match
the CH 3/4 switch setting on the OPTIONAL
PV-RF16 RF Adaptor. Set the VCR/TV
setector on the RF Adaptor to VCR for
playback.
beis playback or begin a recording.
if you have connected the -
Camcorder to your TV using the
PV-RF16 RF Adaptor and want to
watch TV only:
Set the POWER switch to OFF on the
Camcorder.
Then, set the VCR/TV Selector on the RF
Adaptor to TV.
Now, turn the TV ON and select a
channel.
CATV System Installer
This reminder is provided to call the CATV
system installer's attention to Article 820-40
of the NEC in USA (and to the Canadian
Electrical Code in Canada) that provides
guidelines for proper grounding and, in
particular, specifies that the cable ground
shall be connected to the grounding system
of the building, as close to the point of cable
entry as practical.