Panasonic Palmcorder PalmSight PV-L658 - Copying your Tapes (dubbing)

Copying your Tapes (dubbing)
Main Operation
Source (Playing)
Camcorder
Audio/Video
Out TV
(To View)
VHF Connecting ==
Y Cable (not supplied)
Recording:
VCR
To Audio F¿]BH-To Video
In U In
©
Audio/Video Cable
(supplied)
Monitor with your TV
e Turn the TV ON and select its VCR
channel (CH3 or CH4).
s Set the VCR/TV Selector on the
recording VCR to VCR.
Before you begin...
* Connect the Camcorder to VCR as shown
below.
¢ Turn ON both units.
¢ Set the recording VCR’s Input Signal
Selector to LINE.
x Set the Camcorder POWER
switch to VCR.
I Insert a pre-recorded tape
into the Camcorder and a blank tape
with a recording tab into your VCR.
2 Press PLAY on the Camcorder and
when you find the starting point, press
STILL.
D fre REC on your VCR and then
immediately press STILL/PAUSE.
VCR Buttons
£3 > C3 E3
PAUSE/STILL STOP REW PLAY FF REC
E E STILL on the Camcorder and
press STILL/PAUSE on the VCR to
simultaneously start both units.
eu, STOP on both units when
dubbing is complete.
Note:
* Tapes recorded on other VCRs and
used for playback in the Camcorder
must be recorded in SP or SLP mode.
* For technical reasons, dubbing a tape
may reduce its quality.
CAUTION:
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.
45
Y)
po]
©
o
J
“T1
D
©
=
=
=
D
T