Panasonic Palmcorder PalmSight PV-L679 - Page 21

-Camera Recording
' Before you begin... l |
View recording scene on the LCD (Liquid ~ * Connect Camcorder to power source.
Crystal
Display).
s
insert
cassette
with
record
tab
(page
13).
1 Press LCD-OPEN to unlock LCD.
2 Swing LCD fully open and adjust
viewing angle.
Caution:
Rotating partially open LCD monitor
may block cassette door and damage
Camcorder body.
3 Set POWER to CAMERA.
* LCD monitor turns off/on by the
POWER switch.
e Viewfinder shuts off when LCD is
fully opened.and turns back on `
when LCD is closed completely.
e Both Viewfinder and LCD monitor
turn on when LCD is at 180° (see
below left).
This allows both you and the subject
to view the recording. -
vora nO SER
4 Turn BRIGHT control to adjust LCD
brightness level.
5 Press RECORD/PAUSE to start
recording (page 20). :
Note:
¢ Using LCD reduces battery operation time.
s To hear sound while recording, connect
‘PHONE (earphone) earphone (M3 type: not supplied) to
jack 7 Ei ei PHONE jack. Earphone volume cannot be
changed while in CAMERA mode.
* Lock LCD closed when not in use.
EA