Supplying Power
|liJ i _l i[o.[=-11ii [;]1 :_'_ | (q ILV| _L_T'o_;ll
Charge Battery Pack fully before use.
2
POWER
Lamp
[]1 Plug in AC Adaptor.
POWER Lamp lights.
CHARGE
l_' Insert
Lamp (_ Align right side of Battery withlineonAC Adaptor.
_) Press Battery down and slide in
direction of arrow.
CHARGE Lamp lights and then goes
out when charging is done (approx.
1 hour).
Remove Ba__!_J3£
B:_ferrYmaCth:rn__
Use this marker as a reminder to yourself
when the battery is fully charged or in need
of a charge. This marker performs no
function and is for your reference only.
Slide Battery out and off.
• Battery life gradually decreases after
repeated use and recharging. If operation
time becomes very short even after a
sufficient charge, discard Battery properly
(page 11).
Note:
After recharging 5 times, use BATTERY
REFRESH feature as explained on page 11.
LI [.-_-.-! I i[:1 ;iEi| (_ i ril _J :|
A fully charged Battery provides a maximum of about 1 hour 10 minutes of continuous
use. Actual time may vary due to operating conditions. Using the Built-in Light decreases
operating time. 1
Attach
(_ Align Battery with top of mounting
surface.
_) Press and snap into place.
Remove Battery
While sliding BA'r!"ERY RELEASE,
remove Battery.
To Next Page
Loading...
