Panasonic Palmcorder PV-GS59 - Charging Time and Available Recording Time

16
Charging Time and Available
Recording Time
A
Charging Time
Maximum Continuous Recording Time
Intermittent Recordable Time
B
Supplied battery
(PV-GS29)
CGR-DU06
(7.2 V / 640 mAh)
A
1 h 40 min.
B
1 h 50 min. (1 h 25 min.)
C
55 min. (45 min.)
Supplied battery
(PV-GS39/PV-GS59
U.S.A.)
CGR-DU06
(7.2 V / 640 mAh)
A
1 h 40 min.
B
1 h 45 min. (1 h 20 min.)
C
55 min. (40 min.)
Supplied battery
(PV-GS59 Canada
Only)
CGA-DU12
(7.2 V / 1 150 mAh)
A
2 h 25 min.
B
3 h 10 min. (2 h 30 min.)
C
1 h 35 min. (1 h 15 min.)
Optional battery
(PV-GS59 Canada
Only)
CGR-DU06
(7.2 V / 640 mAh)
A
1 h 40 min.
B
1 h 45 min. (1 h 20 min.)
C
55 min. (40 min.)
Optional battery
(PV-GS29)
CGA-DU12
(7.2 V / 1 150 mAh)
A
2 h 25 min.
B
3 h 15 min. (2 h 40 min.)
C
1 h 40 min. (1 h 20 min.)
Optional battery
(PV-GS39/PV-GS59
U.S.A.)
CGA-DU12
(7.2 V / 1 150 mAh)
A
2 h 25 min.
B
3 h 10 min. (2 h 30 min.)
C
1 h 35 min. (1 h 15 min.)
Optional battery
(PV-GS29)
CGA-DU21
(7.2 V / 2 040 mAh)
A
3 h 55 min.
B
5 h 45 min. (4 h 30 min.)
C
2 h 55 min. (2 h 15 min.)
Optional battery
(PV-GS39/PV-GS59)
CGA-DU21
(7.2 V / 2 040 mAh)
A
3 h 55 min.
B
5 h 30 min. (4 h 15 min.)
C
2 h 45 min. (2 h 10 min.)
(The intermittent recordable time refers to recordable
time when the recording and stopping operations are
repeated.)
C
Notes:
• When the Camcorder has been used for a long
time, the Camera body becomes warm, but this is
not a malfunction.
• If the [CHARGE] Lamp does not light up although
the Battery is attached to the AC Adaptor, detach
the Battery and reattach it.
• Since the Battery will not be charged when
the DC Cable is connected to the AC Adaptor,
disconnect it from the AC Adaptor.
• The [CHARGE] Lamp lights up, and charging
starts.
• When the [CHARGE] Lamp goes off, charging
is completed.
• When the battery is completely discharged, the
[CHARGE] Lamp blinks at first, but the battery
is charged normally. When the temperature of
the battery is too high or low, the [CHARGE]
Lamp blinks and the charging time becomes
longer than usual.
3 Attach the charged Battery to the
Camcorder.
 Disconnecting the Power Source
Set the [OFF/ON] Switch to [OFF], and while
sliding the [BATTERY RELEASE] Switch, remove
the Battery downward or DC Cable.
• When attaching or removing Battery, set the
[OFF/ON] Switch to [OFF] and make sure the
[STATUS] Indicator is not lit.
• Hold down the battery with your hand so it
does not fall.