How to transfer the gamma data using the
software (2):
1. Execute the "SCE2.EXE" file by double clicking. The
start-up menu will appear.
2. Select "(
C)" on option pull-down menu, and confirm the
transmission setting as shown.
3. Select "(
O)" on file pull-down menu.
4. Select "GAMMA_USUAL.sce" file, and press "Open."
Select
Select
Select
Press
GAMMA_USUAL.sce
Select 1st file
Select 2nd file
Select 3rd file
Select 4th file
Select 5th file
Select 6th file
red arrow
blue arrow
red arrow
blue arrow
red arrow
blue arrow
red arrow
blue arrow
red arrow
blue arrow
red arrow
blue arrow
5. Select desired gamma data of "MMD2003GAMMA"
folder (MMD2003GAMMA 1-5). Then, double click the
1st, 2nd, 3rd, 4th, 5th and 6th files in order.
When the file is double clicked, the transmission will
start. The red arrow will appear, and then the blue arrow
appear. First, a red arrow will appear, then a blue arrow.
The red and blue arrows will appear alternately.
Note:
If the blue arrow does not appear or the "Error"
indication appears, transmission has failed. In this case,
double click the file again until the blue arrow appears.
PT-60LCX64-K
107
To Next Page
Loading...
