WARNING:
• Not for use in a computer room as dened in the Standard for the Protection of Electronic Computer/Data
Processing Equipment, ANSI/NFPA 75.
• For permanently connected equipment, a readily accessible disconnect device shall be incorporated in the
building installation wiring.
• For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily
accessible.
Product Identication Marking is located on the bottom of the Wireless LAN Adaptor.
Federal Communication Commission (FCC) / IC Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-
1999/IC RSS-102 and had been tested in accordance with the measurement methods and procedures specied
in OET Bulletin 65 Supplement C/IEEE 1528. This equipment should be installed and operated with minimum
distance 0.5 cm between the radiator & your body.
CAUTION:
Be aware of the following limits before using the Wireless LAN Module.
• To use the Wireless LAN Module, an access point needs to be obtained.
• Do not use the Wireless LAN Module to connect to any wireless network (SSID*) for which you do not have
usage rights. Such networks may be listed as a result of searches. However, using them may be regarded
as illegal access.
*SSID is a name for identifying a particular wireless network for transmission.
• Do not subject the Wireless LAN Module to high temperatures, direct sunlight or moisture.
• Do not bend, or subject the Wireless LAN Module to strong impacts.
• Do not disassemble or alter the Wireless LAN Module in any way.
• Do not attempt to install the Wireless LAN Module in any incompatible device.
• Do not remove the Wireless LAN Module from the host product during operations.
• Data transmitted and received over radio waves may be intercepted and monitored.
• To avoid malfunctions caused by radio wave interface, keep the host product away from the devices such as
other wireless LAN devices, microwaves and the devices that use 2.4 GHz and 5 GHz signals when using
the Wireless LAN Module.
• When noises occur due to the static electricity, etc., the host product might stop operating for the protection
of the devices. In this case, turn the host product Off with Mains power On / Off switch, then turn it On again.
• Depending on the area, this Wireless LAN Module may not be available.
Notice (USA only):
• This product has a High Intensity Discharge (HID) lamp that contains mercury. Disposal may be regulated
in your community due to environmental considerations. For disposal or recycling information, please visit
Panasonic website: http://www.panasonic.com/environmental or call 1-888-769-0149.
Notice (Singapore only):
• Complies with IDA Standards ID : DB102345
Notice (UAE only):
• This equipment has been registered with the Telecommunications Regulatory Authority for use in the UAE.
TRA
REGISTERED No: ER0119239/13
DEALER No: DA0081667/12
Read this rst!
4 -
ENGLISH
To Next Page
Loading...
