To Next PageTo Next PageWhy won't my Panasonic PT-VX400NTU power on?
If your Panasonic Projector isn't turning on, start by checking that the power cord is properly connected to both the projector and the wall. Then, verify that the wall outlet has electric supply. Also, make sure the circuit breakers haven't tripped and reset them if necessary. Finally, ensure that the lamp cover is securely installed.
General| Matrix size | 0.63 \ |
|---|---|
| Matrix type | 3-panel (p-Si TFT active) |
| Projection distance | 0.76 - 7.62 m |
| Vertical scan range | 50 - 85 Hz |
| Horizontal scan range | 15 - 80 kHz |
| Projection technology | LCD |
| Contrast ratio (typical) | 2000:1 |
| Screen size compatibility | 30 - 300 \ |
| Projector native resolution | XGA (1024x768) |
| Aspect ratio | 4:3 |
| RS-232 ports | 1 |
| Focus | Manual |
| Throw ratio | 1.2 - 1.9:1 |
| Focal length range | 15.47 - 24.53 mm |
| Aperture range (F-F) | 1.65 - 2.33 |
| Lamp type | - |
| Lamp power | 245 W |
| Lamps quantity | 1 lamp(s) |
| Light source type | Lamp |
| Service life of light source | - h |
| HDCP | Yes |
| Noise level | 35 dB |
| Noise level (economic mode) | 29 dB |
| Dot clock scanning frequency | 162 MHz |
| Full HD | No |
| Supported video modes | 1080i, 480i, 480p, 576i, 576p, 720p |
| Analog signal format system | NTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM |
| Supported graphics resolutions | 1024 x 768 (XGA), 640 x 480 (VGA) |
| RMS rated power | 10 W |
| USB connector type | USB Type-A, USB Type-B |
| Serial interface type | RS-232 |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Component video (YPbPr/YCbCr) in | 0 |
| Placement | Desktop |
| Product type | Standard throw projector |
| Product color | White |
| Power source | AC |
| AC input voltage | 100 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (standby) | 0.48 W |
| Power consumption (typical) | 322 W |
| Operating temperature (T-T) | 5 - 35 °C |
| Operating relative humidity (H-H) | 20 - 80 % |
| Cables included | AC, VGA |
Weight and Dimensions| Depth | 276.8 mm |
|---|---|
| Width | 350.5 mm |
| Height | 96.5 mm |
| Weight | 3500 g |
Covers fire, electric shock, power supply, and installation safety.
Details FCC rules for digital devices and RF exposure.
Outlines essential steps for setting up and operating the projector.
Guidelines for securely handling the projector during transport.
Warnings and conditions for safe projector installation.
Introduces the projector body, remote control, and terminals.
Covers battery installation and setting remote control ID numbers.
Guides on projection methods, ceiling mounts, and screen size.
Step-by-step instructions for turning the projector on and off.
Covers manual and automatic image adjustment for optimal display.
Explains how to navigate the projector's on-screen menus.
Details settings for various input sources like HDMI, VGA, etc.
Options for adjusting contrast, brightness, color, sharpness, etc.
Controls for screen size, zoom, keystone, and aspect ratio.
Configuration for volume, mute, microphone, and audio output.
Explains projector indicators and troubleshooting common problems.
Guides on cleaning outer case, lens, and replacing air filters.
Lists issues like no power, no picture, fuzzy image, and their solutions.
Details serial terminal, communication conditions, and cable specifications.
Table of supported display resolutions and scanning frequencies.
Provides model number, power, LCD panel, lens, and other technical details.
